




2WR4-TPK 2·WIRE TapLink 4-Zone Starter Kit
Complete 2·WIRE TapLink kit including one 4‑Zone transmitter (2WR4‑TX) and four Tap‑to‑Program receivers (2WR1‑RX).
Run up to 4 irrigation zones using only two wires: a single field conductor plus a common return line.
Simple Tap‑to‑Program setup lets you assign each receiver to a zone with a quick tap sequence. No special tools, software, or programming devices required.
Built for outdoor environments with a weatherproof transmitter mounted near the sprinkler timer and fully waterproof receivers that install directly inside the valve box.
Compatible with standard 24 VAC sprinkler timers and valves, making it easy to upgrade existing systems without replacing your controller.
Ideal for repairs or expansions: works with existing multi‑conductor cable as long as two conductors remain functional, or with new 18/2 landscape wire.
Expandable system architecture supports up to 4 transmitters and 16 receivers on a single irrigation system, enabling up to 16 zones over 2‑conductor wiring (limited only by the number of zones supported by your sprinkler timer).
2WR4-TX 2·WIRE TapLink Transmitter
Expansion transmitter for the Pluvion 2·WIRE TapLink system, used to add additional irrigation zones to an existing installation.
Adds 4 extra zones per transmitter, up to a system maximum of 4 transmitters / 16 total zones, subject to the zone capacity of the sprinkler timer.
Works with Tap‑to‑Program receivers (2WR1‑RX) to assign and control new field zones without special programming tools.
Outdoor‑rated enclosure designed for installation near the sprinkler timer.
Compatible with standard 24 VAC sprinkler timers and valves, allowing seamless upgrades to 2·WIRE operation without replacing the controller.
2WR1-RX 2·WIRE TapLink Receiver (2-Pack)
Two Tap‑to‑Program Receivers (2WR1‑RX) for expanding an existing Pluvion 2·WIRE TapLink irrigation system.
Adds one irrigation zone per receiver, allowing flexible system growth up to a maximum of 16 total receivers.
Simple tap‑sequence programming assigns each receiver to a zone in seconds, with no special tools, software, or field programmer required.
Fully waterproof design for direct installation inside valve boxes and other above-ground outdoor locations.
Requires a 2·WIRE transmitter (2WR4‑TX); each transmitter supports up to four receivers.


















2WR4-TRX 2·WIRE 4-Zone Controller Kit
Complete 4‑zone 2·WIRE controller including one 4‑zone transmitter (2WR4-TX), one 4‑zone receiver (2WR4-RX), and mounting hardware.
Controls four irrigation valves from a single receiver, ideal for installations where valves are grouped in sets of four within a single manifold.
Enables 4 irrigation zones over just two conductors: a single field wire plus a common return line.
Works with standard 24 VAC sprinkler timers and valves, making it easy to upgrade existing systems without replacing the controller.
Supports up to 4 controllers per system for a total of 16 zones over 2‑conductor wiring, limited only by the zone capacity of the sprinkler timer.
A great choice when receivers are located in dry or protected installation locations, while the newer TapLink receivers offer the best waterproofing for valve box environments.




Two‑zone controller that operates two irrigation valves over a single field wire, ideal for repairs, add‑ons, or locations where running new cable isn’t practical.
Product includes one transmitter (DTR2-TX) and one receiver (DTR2-RX)
Completely waterproof, fully sealed design built for direct installation inside valve boxes and other damp environments.
Uses solid‑state switching and digital signaling to deliver full‑strength activation at the solenoid, avoiding the weak performance and voltage drop issues common with passive diode‑based multipliers.
Provides stable, consistent operation across long wire runs and systems with limited electrical margin, reducing overheating and long‑term wear on valves.
A compact, purpose‑built solution for small expansions, isolated valve pairs, or two‑zone repairs, without converting the site to a full 2·WIRE architecture.
Compatible with standard 24 VAC sprinkler timers and valves, integrating easily into existing irrigation systems.
DTR20 Duo - Waterproof Two-Zone Repair Module for Damaged Field Wires




Contact
Pluvion Technology Inc.
info@pluviontech.com

Location
205A-1410 Alpha Lake Road
Whistler BC, V8E 0J3, CANADA


© 2026 Pluvion Technology Inc. Pluvion ® is a registered trademark in the United States







